Panasonic HL-SX485S Bedienungs- Und Installationsanleitung Seite 64

Installing the Appliance
Installation
• Veneer or other finish of the furniture the appliance is being built into should be
processed with heat-resistant glue (100°C); otherwise, high temperatures may
cause them to deform.
• There must be no rear wall fitted to appliance housing.
• There must be a gap of at least 45 mm between the wall and the back of the unit
to enable adequate air circulation.
• The fitted cabinet must have a ventilation opening of 50 cm
achieve this, cut back the plinth or fit a ventilation grille. Ventilation slots and
intakes must not be covered.
• Level the piece of furniture the appliance was built into with a spirit level.
• The piece of kitchen furniture the appliance is built into must be secured against
movement, e.g. Attached to the adjacent pieces of kitchen furniture.
• Align the appliance flush with the units and screw it in place.
• When attaching the appliance, make sure the screws are not fastened too
strongly as this may damage the furniture.
• The ventilation slots and air intake points must not be covered. To ensure that
they remain uncovered also observe the installation instructions of any appliance
installed with this oven.
NOTE
„ Ensure that the connector lead does not become trapped or bent.
„ After installation the connector lead must not be in contact with the back or the
62
EN
base of the appliance.
on the front. To
2