GreenWorks GD40BCB Bedienungshandbuch Seite 9

7. Tighten the screws.
3.3 ASSEMBLE THE SHAFT
Figure 3.
1. Loosen the screw on the coupler.
2. Push in the release button on the lower shaft.
3. Align the release button with the positioning hole
and slide the two shafts.
4. Turn the lower shaft until the button locks into the
positioning hole.
The release button must be fixed in the positioning
hole. Using the wrong hole could lead to personal
injury, or damage to the unit.
5. Tighten the screw with the hex wrench.
3.4 ATTACH THE AUXILIARY HANDLE
Figure 4.
1. Loosen the central knob.
2. Remove the cap and the lower support.
Do not miss the spring in the support.
3. Put the auxiliary handle in the lower support.
4. Put the cap to the lower support.
5. Put the entire block in its housing on the shaft.
6. Set the auxiliary handle in the comfortable
position.
7. Lock the auxiliary handle with the central knob.
3.5 USE THE SHOULDER STRAP
Figure 5.
1. Attach the carabiner to the carrying ring on the
pole.
2. Put on the shoulder strap.
3. Adjust the length of the strap so that the
carabiner is about the width of a hand below your
right hip.
4 OPERATION
IMPORTANT
Before you operate the machine, read and
understand the safety regulations and the operation
instructions.
WARNING
Be careful when you operate the machine.
English
NOTE
NOTE
4.1 INSTALL THE BATTERY PACK
Figure 6.
• If the battery pack or charger is damaged, replace
them directly.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, understand, and follow the instructions in
the battery and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery slot.
2. Push the battery pack into the battery slot until
the battery pack locks into place.
3. When you hear a click, the battery pack is
installed.
4.2 REMOVE THE BATTERY PACK
Figure 6.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4.3 START THE MACHINE
Figure 7.
1. Push the lock-out button and pull the trigger.
4.4 STOP THE MACHINE
Figure 7.
1. Release the trigger to stop the machine.
4.5 OPERATION TIPS
Figure 8.
Keep clearance between the body and the machine.
Do not operate the machine without guard in place.
Follow these tips when you use the machine:
• Keep the machine connected to the correctly worn
harness.
• Keep a firm hold with two hands on the machine
while you operate the machine.
• Cut tall grass from the top down.
If grass winds around the trimmer head:
• Remove the battery pack.
• Remove the grass.
5
WARNING
WARNING
WARNING
EN