Dreame R20 Benutzerhandbuch Seite 14

Efficiency a Low Load (10%)
No-load Power Consumption
Rechargeable Lithium-ion Battery Pack
Model
Nominal Voltage
Energy
Nominal Capacity
Rated Capacity
Note: The lithium-ion pack contains substances that are hazardous to the environment.
Before disposing of the vacuum, please remove the battery pack, then discard or recycle
it in accordance with local laws and regulations of the country or region it is used in.
FAQ
If the vacuum is not working properly, please refer to the table below.
Errors
Vacuum does not work
Weak suction force
Motor is making a
strange noise
The first indicator is
red after turning on the
vacuum
The first indicator blinks
red when charging the
vacuum
The battery indicator
does not light when
charging
77,01%
0.1W
P2033-8S1P-GYA
29.6V
81.4Wh
2900mAh
2750mAh
Possible Causes
Vacuum is out of battery or
low on power.
Overheat protection mode
triggered by a blockage.
Suction opening or air duct is
blocked.
Dust cup is full and/or filter
assembly is clogged.
Attachment is blocked.
Main suction opening or
carbon fiber rod is blocked.
Battery pack is damaged.
The charger is incompatible.
The charger does not plug into
the vacuum well.
The battery is fully charged
and went into sleep mode.
14
Solutions
Fully charge the vacuum, then
continue to use it.
Clean the suction openings or
air duct. Wait until the vacuum
cools down, then reactivate it.
Clear any blockage from
suction opening or air duct.
Empty the dust cup and clean
the filter assembly.
Clear any blockage in the
attachment.
Clear any blockage in the main
suction opening or extension
rod.
Please contact the after-sales
service department for
maintenance.
Only use the original charger
to charge the vacuum.
Check whether the charger is
properly plugged into the
vacuum.
The vacuum can be used
normally.