Cleaning the Vacuum
Wipe the vacuum with a soft dry cloth.
•
Cleaning the Dust Cup, Pre-Filter, and Cyclone Assembly
Press the dust cup bottom cover release button to empty its contents.
•
Push the dust cup release switch in the direction indicated by the arrow and
•
gently detach the dust cup from the vacuum.
Note:
The vacuum's cleaning efficiency diminishes if the dust cup reaches the "MAX"
•
mark. Empty the dust cup promptly to restore performance.
Before emptying the cup, ensure the vacuum is disconnected from power, and
•
refrain from pressing its power button.
Begin by removing the pre-filter, then lift the handle of the cyclone assembly.
•
Rotate it counterclockwise until it stops, and then pull to lift out the cyclone
assembly.
Wipe the dust cup with a soft, damp cloth, ensuring excess moisture is wrung out
•
before use.
Caution: To prevent the risk of electric shock, do not rinse the dust cup with water.
Rinse the cyclone assembly and pre-filter until they are thoroughly clean. After
•
washing, allow them to air dry for at least 24 hours.
Installing the Dust Cup, Pre-Filter, and Cyclone Assembly
Insert the cyclone assembly vertically into the dust cup, ensuring the handle
•
aligns with the slot on the left side of the dust cup. Turn the handle clockwise
until it locks, then flip it down.
Place the pre-filter with its front side facing up into the cyclone assembly.
•
Tilt the dust cup to align its slot with the clip on the vacuum. Gently push the dust
•
cup until it clicks into place.
Cleaning the Filter
Follow the figure to remove the dust cup.
•
Pull down the filter in the direction indicated in the figure to detach it from the
•
vacuum.
Clean the filter using clean water, ensuring a 360° rotation to thoroughly
•
eliminate all dust trapped in the filter. Gently tap the filter multiple times to
remove any excess dirt.
Allow the filter to air dry for 24 hours.
•
Note:
It is recommended to clean the filter once every 4 to 6 months.
•
Use only clean water for washing the filter; do not use detergent.
•
11