Charging Methods - Dreame R20 Benutzerhandbuch

Flexible Combination Tool
•
Charger
•
2-in-1 Charging & Storage Mount (2×Includes screws, 2× Wall Plugs, Mounting
•
Template Sticker)
Installation
2-in-1 Charging & Storage Mount Installation Guide
Ensure that the bottom of the mounting template sticker is level and positioned
•
at least 103 cm from the ground.
Utilize a power drill equipped with an 8 mm drill bit to create holes at each
•
marker on the mounting template sticker. Subsequently, insert a wall plug into
each hole.
Align the locating holes on the mount with the corresponding holes on the wall.
•
Secure the mount to the wall using the provided screws.
Note:
The 2-in-1 charging & storage mount is an optional accessory. Installation can be
•
customized based on your specific requirements.
The mount should be installed in a cool, dry location with an electrical outlet in
•
close proximity.
Prior to installation, ensure that there are no electrical wires or pipes in the space
•
directly behind where the mount will be positioned.
Charging
Note:
Before using the vacuum for the first time, it is essential to fully charge it.
•
A complete charge will take approximately 4 hours.
•
Extended use of Turbo Mode during vacuuming may cause the battery to heat
•
up, leading to increased charging time. Allow the vacuum to cool down for 30
minutes before initiating the charging process.

Charging Methods

Charging the vacuum with the provided charger.
•
Charging the vacuum on the designated charging mount.
•
8