Werbung
f you installthe alarm on an A-frame or s oped ceiling, place it4 inches
( 1 0 cm) below the highest peak.
AREA
ANYWHERE
N THIS
Installation
Procedures
Before installation, you will need to test the alarm, making sure it is
functioning properly within the router's range.Then, install the alarm as
follows:
1 Mark holes on the ceiling or wall using the mounting bracket asa
guide.
2 Drill holes at the two marked positions with a drill bit. Insert the anchor
plugs, then attach the mounting bracket using the provided screws.
3. Attach the alarm to the mounting bracket,then turn clockwise to lock
the alarm.
4 Test the alarm by pressing the Test/SiIence button. It should flash red
three times with three short beeps,and then flash blue.
NOV
AREA
IN THIS
AREA
O
O
O
d)
Werbung
