Fronius DPS 2500 Bedienungsanleitung Seite 43

Putting the power source into service
Safety
Danger due to work on the device.
If the power source is connected to the mains electricity supply during installation, there
is a high risk of very serious injury and damage.
▶
▶
▶
Connecting up
the power source
Connecting the mains cable to the mains plug
WARNING!
Before putting the machine into service for the first time, read the section hea-
ded "Safety rules".
Only carry out these preparations if the mains switch is in the "0" position
Only carry out these preparations if the mains cable is unplugged from the mains.
L 1 L 2 L 3
Connect the mains cable to the mains
1
plug
Connect up the control leads as
2
shown in the operating instructions for
the interface
Connect the current cables to the cur-
3
rent sockets
43