two trees TS2 Bedienungsanleitung Seite 9

X-axis parallel adjustment method
Y axis Left
Frame
Attention: Please make sure the X-axis crossbeam
(check ruler marks on both sides as reference
otherwise it would affect movement of Y-axis and engraving
Step I. Move the left component of the Y axis to the scale 300 (A1)
2. Loosen the two screws on the synchronizing
press the to move the right component of the Y axis to 300 of the scale (A2).
Then lock the two screws on the synchronous
affect the Y axis movement and the engraving
3. f you don't understand anything, please scan the QR code on the cover of the manual
watch the relevant video tutorials.
13
synchro wheel
Optical axis
Screw
Y-axis Right
Frame
is parallel to
) while installation,
effects.
wheel with a hexagonal wrench, and then
wheel (if the screws are not locked, it will
effect)
2.2 Installation of Laser
Laser Module
M3*6 Screw Bolt
000
o
to
Module
xl
x4
101
o o o o
O
o o o o o
o
14