two trees TS2 Bedienungsanleitung Seite 18

MACHINE TESTING GUIDE
1. Turn on the power switch, connect the
computer, and start the machine
2. Movement test:
Control the machine to move up, down, left and
moving direction is correct (Figure AOI ), and
(Figure A02)
3. Laser emission test:
The software imports the custom icon, click
observe whether the laser module emits blue
4. Test the files in the TF card.
Note: laser will generate heat and glare, which
avoid injury.
soo
OOO
10
( Fig. AOI )
o
Kind tips:
I. If the buzzer triggers the machine during the engraving
cally stop. This belongs to the flame alarm trigger.
recover (or to recover through the reset function
2. Before the machine moves, please check whether
31
USB data cable of the engraving machine to the
right on the software, check whether
check whether the moving distance is correct
on the ight (low light). Wear protective glasses
ight.
may cause harm. Please follow the instructions
process, the machine will automati-
It is recommended to restart the machine
on the software).
the probe will hit other objects.
APP CONNECTION
The WIFI of this machine
been set up when
board will send
number of the main
the
1. Open the Laser
12345678, and connect
2.0pen the APP and enter
and click connect.
to
3.After the APP slicing
uploading files. If the upload
to
Connection
options
to
is a signal sent by the ESP32 chip of the main
the machine eaves the factory. After the
out the WIFI network with the name Laser XXXXX
board, the serial number of each machine).
XXXXX network found by the mobile phone
to the network.
the connection options interface.
is completed, you need to insert the TF card
fai s, please confirm whether the TF card
Set UP
(Select software
language here )
APP main interface
EN
board. The machine has
machine is turned on, the main
(XXXXX refers to the serial
all different)
connection, enter the password
Enter the IP address: 192.168.4.1
into the motherboard when
is norma
Connect
32