two trees TS2 Bedienungsanleitung Seite 17

A05
A07
Cut 3"
Go to Or i
o
O
Cut Pith
A09
Cut
Cut F .th
29
All
A06
Run
Go to tricin Current Positior v
Job Or. gin
Cut
Cut Optimization Setting
A08
Edit Macro - LightBurn 0.9.18
Button Label: Cut 2mm
Macro contents
GI z-1 noo
A10
Stut
iSfiGCmi.
stut
Job Or i O
o
Opt'
rsz
LaserCRBL Custom Auto Focus Import Tutorial
Add Custom Button
LaserCRBL supports custom button. Right-click
It is recommended to use the custom button
from the TF card of the manufacturer (USB flash disk).
TS2-CustomBut
Figure 5.1 Installation Package
How to oad into software:
n LaserCRBL software, right-click the mouse in the blank
shown in figure 5.2) - > import custom button,
obtained before and the custom button zip can be imported.
to complete the installation of the custom button.
on the front of the manual to watch the relevant
Add Custom Button
's[I.oox] 61 [I.oox]l
Lock position (click to reorder)
Export custom buttons
Import custom buttons
Figure
Introduction of button function
find edge
choose
on outline
low light
set the origin
reset opening choose
the light strong light
display machine
parameters
the button area to add new custom buttons.
set by the manufacturer, which can be obtained
z
for Custom Button
space next to button at the bottom
and then select the package for custom button
Press (Y) until no window pops up
(if you are unclear, you can scan the QR code
video tutoria s)
Import custom button x
Import • Boundary(SYZE) •?
5.2 How to add
Adjust the cutting
Z axis lift
engraving
height
Set the
continue to carve
engraving height
EN
(as
30