two trees TS2 Bedienungsanleitung Seite 14

6. Set engraving speed, engraving energy, and engraving
1 . The recommended engraving speed is 1 000, which
value after repeated experiments. Of course, you can increase or decrease this speed according
to your preference. A faster engraving speed will save time but lead to the decline
ing effect. Slower speed is the opposite.
2. In laser mode, there are two instructions:
engraving in "l bit jitter" mode, and M3 instruction
ony M3 instruction on the laser, please check
configuration. Please refer to the official instructions
3. Choice of engraving energy. Choose it according
4. Finally, set the size and click the "Create'
parameters.
Target image
Speed
Engaving Speed 1000 mm/min
Laser Opti ons
Laser ON v Laser OFF
1000
s-hffN
Image Size and Posi tion [mm]
Ü Autosize 300
EXIF
Offset
Save GCODE file
Click "File" in the menu at the top of the software
select "Save". Copy the saved .nc file to the TF card and insert the TF card into the engraver to use
the file to engrave your work.
Use the "MKSLaserTool" software in TF to add preview codes to Ccode files.
23
size
is considered to be a relative appropriate
in the engrav-
M3 and M4. M4 instruction is recommended
is recommended for other cases. f you have
whether the laser mode is used in the CRBL
of LaserCRBL for CRBL configuration.
to different materials.
button to complete the setting of al engraving
The default engraving speed is 1000
and can be adjusted as required
Set the energy value. Improper energy
will affect the engraving effect
Enter the size of the graph you want
to engrave
interface, enter the drop down menu, and
CONNECT
I. Connect the machine
cable.
2. Plug in the power.
for
3. Open LaserCRBL on the computer.
4. Select the specific
5. Click the lightning
is lit, it indicates that the connection
Generally, the COM
devices are connected
manager of the windows
port number one by one.
Device Manager
File Action View Help
v DSKTOP-E
Audio inputs and outputs
Computer
Disk drives
Display adaptors
Firmware
Human Interface Devices
IDE ATA,'ATAPI controllers
Keyboards
Mice and other pointing devices
Monitors
Ports .COM & LPTJ
USB-SERIAL CH340 (COME)
(COMI)
print queues
Processors
COM carv16
PC
with the computer installed with LaserCRBL software
port number and baud rate 1 15200 (Figure
sign. When the ightning sign changes to the red "X" and the direction
is successful. (Figure A.I I )
port does not need to be selected manual
to the computer, you can find the port of the machine
system (as shown in Figure A.09). A simpler way is to try the displayed
LaserGRBL
Grbl
Choose the correct port
AIO
Choose baud
Successful
Baud -115200
All
EN
with USB data
A.I O)
sign
y, unless multiple serial port
in the device
v3.8.O
File Colors Language Tools
Lightning sign
rate 115200
soo
OOO
o Buffer I
Estimated Time:
nes:
24