two trees TS2 Bedienungsanleitung Seite 12

WIRING INSTRUCTION
1.1 Cable Marking Explaination
Endstop Switch Cable
Stepper Motor Cable
Stepper Motor Cable
Endstop Switch Cable
Stepper Motor Cable
A(2PlN)» Laser Signal Cable
Flame Detector Signal Cable
Fan Line
Note: PIN refes to the quantity of cable connecting
1.2 Wiring diagram
X(2PlN)-axis
Stepper
Motor Cable Switch
Stepper
Motor Cable Signal
Laser Signal
Cable Switch
Note: 1. Please rnake sure all wiring correct before
2. Manually push the nnachine before powering
movement track (the motor will be pushed
powered on, and the mainboard will be slightly
19
to feel stuck when pushing)
pins
Endstop
Stepper
Cable Motor Cable
Flame Detector stepper
Motor Cable
Cable
Endstop
Fan Line
Cable
turn on the machine.
on to see if the wire will affect the rnachine's
after the wire is inserted, and the mainboard will be
locked when it is powered on, so that it is normal
CRBL BEGINNER'S GUIDE
1. Software Downloading
LaserCRBL is one of the most popular DIY laser engraving
in LaserCRBL website http://lasergrbl.com/download/
on the TF card from the manufacturer or USB flash disk).
Brief introduction:
LaserCRBL is easy to use. However, LaserCRBL only supports
Win 8 / XP/Win 10).
For Mac users, you can also choose LightBurn,
but its not free. And this software also supports
Note: The engraving machine needs to be connected
the software of the engraving machine cannot
2. Software Installation
Double click the software installation package
until the installation is complete.
Setup - LaserGR3L Rhyhorn
Select Additü»nal Tasks
VVH&Iadditional tasks shodd be performed?
Select addbonal tasks you vvould to perform whie inst&'g LaserQBL,
the' did Next.
Additions shortcuts:
Create a desktop shortcut
Next >
software, which can be downloaded
(The installation package is also available
Windows system (Win
which is also an impressive engraving software,
Windows system.
with the computer during engraving, and
be turned off.
to start the software installation and click "Next"
EN
7 /
20