Sartorius 16420 Betriebsanleitung Seite 12

Fig. 4
12 Startup
– Plug the optional foot switch into the designated socket located on the rear panel.
(see Fig 3, 3). Fasten the plug to the socket by turning it clockwise.
– Plug the power cable into the male power socket on the back of the Sterisart
Universal pump and into a grounded electrical outlet (Fig. 3, 2).
– Use the On| Off switch (Fig. 3, 1) at the front of the Sterisart Universal pump
to turn it on.
After connecting the power, a boot sequence will appear for 6 seconds with relevant
information (Fig. 4). This displays the current software version of the main board
(main firmware), the software version of the display and control unit (UI firmware)
as well as the device bus address (Fig. 4).
During startup, the control unit carries out a self test whereby the internal barcode
scanner is turned on for a brief time.
After a successful switch-on test, the system is factory set to switch into the manual
operating mode (see Fig. 6).