Werbung
Safety and operating instructions
EN
BCP BL6-I06
Press the trigger to wake up the tool and leave standby mode. The first time
the trigger is pressed the tool will run directly in clockwise direction, even
if the operating switch is set to counterclockwise! The second time the trigger
is pressed, the tool is awake and will run in the direction set by the operating
switch.
Standby behaviour
Valid from Serial No. A3482445
To save battery power the tool will automatically switch to a standby mode
when inactive. All LEDs will be off in standby mode.
Press the trigger to wake up the tool and leave standby mode. The first time the
trigger is pressed the tool will not run. The second time the trigger is pressed,
the tool is awake and will run in the direction set by the operating switch.
Maintenance
Service instructions
Overhaul and preventive maintenance is recommended at regular intervals once
per year or after maximum 250.000 tightening depending on which occurs
sooner. More frequent overhaul may be needed if used at high torque and long
tightening times. If the machine is not working properly, it should immediately
be taken away for inspection.
At the overhauls, all parts should be cleaned accurately and defective or worn
parts (i.e. O-rings) should be replaced.
Disassembling/Assembling
It is important that the machines threaded connections are tightened properly;
i.e. in accordance with the specifications on the exploded views.
Cleaning/Inspection
Clean all parts thoroughly in white spirit or similar cleaning agent. After the
cleaning, inspect all parts. Damaged and worn parts should be replaced.
Lubrication
Lubricate specially gears and clutch with grease containing molybdenum disul-
phide (e.g. Molykote BR2 Plus). Please see exploded views. Lubricate o-rings
and threaded connections with grease before assembling.
Useful information
Log in to Atlas Copco www.atlascopco.com
You can find information concerning our products, accessories, spare parts and
published matters on our website.
Ergonomic guidelines
Consider your workstation as you read through this list of general ergonomic
guidelines and see if you can identify areas for improvement in posture, compo-
nent placement, or work environment.
• Take frequent breaks and change work positions frequently.
8
© Atlas Copco Industrial Technique AB - 9836 962600 00
Werbung
