Werbung
BCP BL6-I06
The tightening torque is adjusted by altering the tension of the clutch spring by
means of the adjustment disc and the key provided. Place the key in the hole in
the front part. The adjustment key is to be turned clock-wise to increase the
tightening torque. Always finish the adjustment at a "holding position" (located
each 1,5 turns of the key). If the torque setted is too high, there will be no click-
sound from the clutch and the green LED will not lighten, but the motor will be
shut off.
To prevent the screw joint from being damaged, it is recommended to start at
low torque setting.
Don't adjust the torque over the maximum recommendation as it will result
in improper function and faster wear.
Battery chargers
Use only Atlas Copco battery charger (see optional accessories). Please see sep-
arate instructions delivered with the charger.
Battery Packs
Fully charge new or long time unused battery packs before using your battery
machine. Full loading capacity of battery pack is reached after 4 – 5 charg-
ings.
The contact points of chargers and battery packs must be kept clean.
If the machine will not be used for 100 hours or longer: separate the battery
from the machine. Otherwise the electronics will discharge the battery.
Battery Pack Reception
Put the battery pack in the battery machine so that the clamps are secured. The
battery can be placed in two alternative positions, pointing forward or back-
ward, for best accessibility and balance. Removal of Battery Pack: Press down
the button, then take out the battery pack of the battery machine.
Since a battery discharge itself slowly, it should remain in the charging unit
which provides a trickle charge.
Signal lights
The green LED indicates an OK tightening, i. e. the machine has been shut off
by the clutch. When the battery energy is not sufficient for any more correct
tightening, the motor will be shut off and the yellow LED will light up.
Screwdriver direction
Direction
Clockwise
Anti-Clockwise
Standby behaviour
Valid to Serial No. A3482444
To save battery power the tool will automatically switch to a standby mode
when inactive. All LEDs will be off in standby mode.
EN
LEDs
Off
Flashing rotatory red & green
© Atlas Copco Industrial Technique AB - 9836 962600 00
Safety and operating instructions
7
Werbung
