Fronius Symo 3.0-3-S Serviceanleitung Seite 106

Closing the device:
106
(4)
(4)
2
5
1 6
7
(4)
(4)
1
NOTE! To avoid damaging the
base shell, do not angle the invert-
er by more than 11°.
WARNING! Wait for the capaci-
tors to discharge before continu-
ing.
Lift the inverter from the Datcom area,
disconnecting the connection to the
wall bracket
Detach the inverter by lifting it upwards
Undo the four 5x18 TX25 screws and
seal rings (4) and remove the power
stage set cover by lifting it clear
NOTE! To ensure a sufficient
EMC connection is established, all
EMC springs must be present
Make sure that the ten EMC springs
are seated correctly - slight notches
hold the EMC springs in place