Start-Up; Teaching-In - HomeMatic HmIP-SRH Bedienungsanleitung

Start-up

5 Start-up
5.1

Teaching-in

Please read this entire section before starting
the teach-in procedure.
First set up your Homematic IP Access Point via
the Homematic IP app to enable operation of
other Homematic IP devices within your system.
For further information, please refer to the oper-
ating manual of the Access Point.
To integrate the window handle sensor into your system
and enable it to communicate with other Homematic IP
devices, you must teach-in the device to your Homemat-
ic IP Access Point first.
To teach-in the window handle sensor, please proceed
as follows:
• Open the Homematic IP app on your smart-
phone.
• Select the menu item "Teach-in device".
• Remove the battery compartment cover (D).
Therefore, push the cover with little pressure to
the side (see figure 2).
• Remove the insulation strip from the battery
compartment (E) to activate the device. Teach-in
mode remains activated for 3 minutes.
32