Scheppach AB1700 Originalbetriebsanleitung Seite 19

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
We hope your new tool brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability
laws, the manufacturer of this device assumes no lia-
bility for damage to the device or caused by the device
arising from:
• Improper handling.
• Failure to comply with the operating manual,
• Repairs carried out by third parties, unauthorised
specialists.
• Installing and replacing non-original spare parts,
• Improper use,
• Failures of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE 0113 not being observed.
We recommend:
Read through the complete text in the operating instruc-
tions before installing and commissioning the device.
The operating instructions are intended to help the user
to become familiar with the machine and take advantage
of its application possibilities in accordance with the
recommendations. The operating instructions contain
important information on how to operate the machine
safely, professionally and economically, how to avoid
danger, costly repairs, reduce downtimes and how to in-
crease reliability and service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in your
country. Keep the operating instructions package with
the machine at all times and store it in a plastic cover
to protect it from dirt and moisture. Read the instruc-
tion manual each time before operating the machine
and carefully follow its information. The machine can
only be operated by persons who were instructed con-
cerning the operation of the machine and who are in-
formed about the associated dangers. The minimum
age requirement must be complied with.
In addition to the safety notices contained in this operat-
ing manual and the particular instructions for your coun-
try, the generally recognised technical regulations for
the operation of identical devices must be complied with.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions and
the safety information.
2. Device description (Fig. 1-5)
1. Engine housing
2. On/off switch
3. Handle
4. Oil filler hole/sight glass
5. Additional handle
6. Tool receiver
7. Pointed chisel
8. Locking bolts
9. Clamping screw
10. Locking switch
3. Scope of delivery
• (1x) Demolition hammer
• (1x) Carrying case
• (1x) Oil can
• (1x) Pointed chisel
• (1x) Flat chisel
• (1x) Hexagon spanner (A)
• (2x) Spare carbon brush
• (1x) Operating manual
• Open the packaging and carefully remove the de-
vice from the packaging.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
• If possible, keep the packaging until the expiry of the
warranty period.
• Familiarise yourself with the product by means of the
operating instructions before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Replace-
ment parts can be obtained from your dealer.
• When ordering please provide our article number as
well as type and year of manufacture for your equip-
ment.
www.scheppach.com GB | 19