Scheppach SM150L Originalbetriebsanleitung Seite 27

9. Cleaning and maintenance
Always pull out the mains power plug before start-
ing any cleaning work.
Cleaning
• Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
• We recommend that you clean the device immedi­
ately each time you have finished using it.
• Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents or
solvents; these could attack the plastic parts of the
equipment. Ensure that no water can seep into the
device. The ingress of water into an electric tool in­
creases the risk of an electric shock.
Maintenance
There are no parts inside the equipment which require
additional maintenance.
Service information
Please note that the following parts of this product are
subject to normal or natural wear and tear, and are
therefore also required as consumables.
Wearing parts *: grinding medium
* May not be included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
10. Electrical connection
The installed electric motor is factory connected
ready for operation. The connection meets the ap-
plicable VDE and DlN regulations.
The connection made by the customer as well as
any extension cables used must comply with all
relevant regulations. Connection and repair work
on the elctric equipment must be carried out by a
qualified technician only.
Damaged electrical connection cables
The insulation on electrical connection cables is often
damaged.
Possible causes:
• Pressure points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been improp­
erly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the wall
outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life­threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are dis­
connected from electrical power when checking for
damage.
Electrical connection cables must comply with the ap­
plicable VDE and DIN provisions, and the local power
supply regulations.
Only use connection cables marked with H05VV-F.
The printing of the type designation on the connection
cable is mandatory.
AC motor
• The mains voltage must be 230 V~
• Extension cables up to 25 m long must have a
cross­section of 1.5 mm
Connections and repair work on the electrical equip­
ment may only be carried out by electricians.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Electrical control data
Connection type Y
If the mains connection cable of this device is dam­
aged, it must be replaced by the manufacturer, their
service department or a similarly qualified person to
avoid dangers.
www.scheppach.com
.
2
GB | 27