Ii - 8 Error Messages - HEIDENHAIN ND 780 Handbuch

II - 8 Error Messages

The following table provides a complete list of error messages that
may be received from the ND 780 DRO.
An explanation of each error message is provided in the following
table.
DRO Error Message
Power was off. Press any key to
continue.
Contamination & Frequency Error:
Press C to clear error.
Contamination Error: Press C to clear
error.
Frequency error: Press C to clear error.
Miscount error: Press C to clear error.
Display Overflow error: Move within
display range.
Error: The valid range for number of
holes is 1-99.
Error: The radius must be greater than
0.0.
Error: The spacing must be greater than
0.0.
Error: The start and end points can not
be the same.
Error: The distance from the center is
not equal to the radius.
Error: The ARCCOS function can only
operate on values from - 1 to 1.
ND 780
Explanation
ND 780 power was just cycled.
Contamination, and frequency errors occurred at corresponding encoder. User
intervention to monitor, and/or correct the encoder.
Contamination error occurred at corresponding encoder. User intervention to
monitor, and/or correct the encoder.
Frequency error occurred at corresponding encoder. User intervention to monitor,
and/or correct the encoder.
Miscount error occurred at corresponding encoder. User intervention to monitor,
and/or correct the encoder.
The encoder is currently out of the display range specified by the user. Move the
encoder to within the display range, or modify the encoder display.
The number of holes defined for the current pattern is out of range. User must
adjust the number of holes.
The user defined radius must be greater than zero to define a circle.
The spacing between holes in a pattern must be greater than zero to define a
pattern.
The start, and end points of the field must be unique to define a line.
The distance from the center value is invalid, and must be modified by the user.
Range error on the value to fetch the arccos of.
113