1St Step: Enter Data - HEIDENHAIN ND 780 Handbuch

1st step: Enter data

Press FEATURES soft key.
Press CIRCLE PATTERN soft key.
PATTERN TYPES
Enter the type of circle pattern (full). Cursor to the
next field.
HOLES
Enter the number of holes (4).
CIRCLE CENTER
Enter the X and Y coordinates of the circle center
(X = 10), (Y = 15). Cursor to the next field.
RADIUS
Enter the radius of the circle pattern (5).
START ANGLE
Enter the start angle (25°).
STEP ANGLE
Enter the step angle (90°) (this can only be changed if
entering a "segment").
62
I Operating Instructions