Encoder Setup - HEIDENHAIN ND 780 Handbuch

Encoder Setup

Encoder Setup is used to set the encoder resolution, and type (linear,
rotary), count direction, reference mark type.
The cursor will default to the ENCODER SETUP field upon opening

Installation Setup. Press ENTER. This opens a list of 3 possible
encoders, labeled INPUT X1 X2, or X3.
Scroll to the encoder input to be added, or changed, and press

ENTER.
The ENCODER SIGNAL field will automatically be determined.

Cursor will be in the ENCODER TYPE field, select the encoder type

by pressing the LINEAR/ROTARY soft key.
For linear encoders, cursor to the SIGNAL PERIOD field, and use

COARSER, or FINER soft keys to select the encoder's signal period
in µm (2, 4, 10, 20, 40, 100, 200, 10 240, 12 800), or type in the exact
signal period desired. For rotary encoders, enter the signal period
directly. See "Encoder Parameters" on page 97 for values.
In the REFERENCE MARK field, press the REF MARK soft key, then

select either the NONE, SINGLE, OR CODED soft key for the
reference signal.
88
II Technical Information