Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DEFAULT SETTINGS
• Channel 1 – gate control mode
• Channel 2 – mode controlling electric strike of a pedestrian gate
• Pulse duration: 0.5s
• IN1 – assigned to channel 1: gate closing signal
• IN2 – assigned to channel 1: gate opening signal
• NO limit switches
Changes in the configuration are made via the EXTA LIFE application after pairing ROB-21 with
the EFC-01 controller.
ADDING DEVICE TO EFC-01 CONTROLLER
In order to add ROB-21 to the EXTA LIFE system, it is necessary to connect the EFC-01 controller
and install the mobile application. The ROB-21 must be connected to the power supply voltage.
1. After starting the application, go to "Devices".
2. Select the "Receivers" and press the "+" button. This will start the process of searching the
receiver, which takes a maximum of 60 seconds. If the receiver is found, you can end the search
earlier by pressing the "Stop" button. Once found, a receiver within range of the controller will
automatically appear on the list with the default name "ROB-21 + 6-digit serial ID number".
3. Press the "TEST" button – this will allow you to quickly locate the receiver. During testing ROB-
21, its outputs are activated for approximately 1s and the STATUS LED lights up green.
4. Select the box next to the "TEST" button. This way you will select the receiver to be paired with
the EXTA LIFE controller. You can select more than one receiver that has been found.
5. Press the "PAIR" button. After a while, the receiver will be saved in the system and visible on
the list of devices in the "Receivers". There are always 2 channels visible.
6. In further steps, you can name the receiver, assign it a different icon, perform configuration and
perform other operations available by the device and the application.
Werbung
