Herunterladen Diese Seite drucken

Cleanfix R 43-1100 Bedienungsanleitung Seite 9

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

5 Polishing/cleaning
For these tasks, we advise using the red pads.
This is fastest way of removing smears and scratches and
6. After-sales service is guaranteed
For repairs please contact your specialist dealer or one of
the Cleanfix Service Shops.
You will be given expert and quick service.
7. It is essential that you heed the following advice
When cleaning or conducting maintenance on the machine,
changing parts or re-equipping, the drive unit must be
switchedoff and the mainsplug pulled out.
The mains cable must not be damaged by running over it,
crushing it, pulling it or similar actions.
The mains cable must be regularly checkedfor damage.
The machine
must not be used if the mains cable is not in
perfect condition.
When using or replacing the mains cable or the appliance's
connecting
cable,
the manufacturer's
always be observed.
When replacing the connecting sockets of the mains cable
or of the appliance's connecting cable, ensure that they
offer sufficient splash-protectionandmechanicalstrength.
producing the typical wet gloss.
Warning! This machine is only designedfor use on level
surfaceswith a maximum gradient of up to 50.
Warning! This machine is not permitted for useon public
paths or roads.
When transporting the machine in lifts, the shaft/handle
should be put in a verical position so that it does not catch
on the lift shaft walls. The shaft/handle is automatically
protected from being thrown back by the patented
shaft/handle adjustment mechanism.
Only spraying and cleaning agentsmay be usedwhich are
suitable for the appliance's application. Never use readily
flammable,
substancesor substances which endanger health.
Repairs, including the installation of spraying agent pipes
instructions
must
and tubes, may only be carried out by approved service
agents or by specialists familiar with all of the relevant
safety regulations.
combustible,
toxic,
caustic
or
irritant

Werbung

loading

Diese Anleitung auch für:

R 53-1100