PCE Instruments PST 1 X Bedienungsanleitung Seite 36

6.1.4 Saving a measurement
When a measurement is started, the device automatically starts recording. However, the
measurement series is only saved if OK is pressed after the measurements have been completed.
If more than one AVG sample has been set in the Measurement menu item, this number of
measurements must first be recorded before the measurement series can be saved. After a
measurement, the next measurement starts automatically as soon as the set limit value is
exceeded. If the set number of measurements has been completed and a new series of
measurements is then automatically started, the series of measurements already completed is
automatically saved.
The measurement can be ended prematurely by pressing the Back key but the recording will not
be saved in this case.
6.1.5 Confirm measurement start
Confirmation of the measurement start can be set in the Measurement menu under the Mode
menu item. This mode can only be used during manual operation.
If confirmation of the measurement start is activated, you will be asked to confirm whether the
measurement should actually be started by pressing the OK key after starting the measurement.
This prevents the measurement from starting too early. For consecutive measurements, a
confirmation is requested before each new measurement.
© PCE Instruments
33