Menu; Measurement - Pce Instruments Pst 1 X Bedienungsanleitung

5

Menu

5.1

Measurement

The Measurement menu contains all the settings required to parameterise the measurement.
Seeting
Measurement mode
AVG samples
Measurement unit
Limit value
Pre-run
Post-run
Sampling rate
Measurement
duration
Factory settings
Description
You can choose between manual and
automatic measuring
Confirmation of the measurement
start can also be set for manual
mode.
The AVG measurement samples
indicate how
measurements/peel
measurement series
averaged.
Unit of the displayed peel force
The measured value in Newtons from
which a measurement is to be started
The time in seconds that should be
recorded before the limit value is
exceeded.
If the value is set to 2 s, the last two
seconds before the limit value is
exceeded are also saved.
The time in seconds that is to be
saved after the sampling length of
100 mm.
The recording of a peel test consists
of the pre-run, the duration of the
sampling length and the post-run.
After the duration of the sampling
length, the additional seconds set are
also saved.
Specifies the frequency of the force
measurement and the data logger.
Specifies the total duration of a
recording. This is made up of the pre-
run, the duration of the measurement
depending on the feed rate and the
post-run.
Reset the measurement settings to
ist factory default settings
© PCE Instruments
27
Setting options
Manual
mode. Automatic
Confirm
measurement
On/off
...
0
many measurements
tests per
are to be
N/cm
N/mm
0 ... 500 N
0 ... 10 s
0 ... 10s
2 Hz, 10 Hz, 25 Hz, 50 Hz,
100 Hz
Cannot be set as it is
calculated
parameters
start of
99 series of
from other