ULTIMATE SPEED UPK 10 D1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 16

Using the device
which you want to inflate.
To do so, please proceed as
follows.
Use the "M" menu button
„
to select the desired unit of
pressure. The units available are
bar ("bar"), kilopascal ("KPa"),
kilogram per square centimetre
("KG/CM²") and pound per
square inch ("PSI") (see Fig. E).
Use the "+" button
„
"-" button to select the desired
4
pressure. To speed up the selec-
tion, you can keep the respective
button pressed down. Pressure
settings between 0.3 bar and
3.5 bar are possible in 0.05 bar
steps (see Fig. E).
Note: While preselecting the
pressure, the digital pressure gauge
will flash with the pressure display
. If a button is not pressed for at
6
least 10 seconds, the display will
display the ACTUAL value of the
pressure. The pressure which has
been set remains stored.
Switch on the integrated com-
„
pressor by switching the On/Off
switch for the compressor
"On" (position I).
The compressor will start and
„
pump up the inflatable item.
You can switch off the compressor
„
at any time by switching the On/
Off switch for the compressor
to "Off" (position 0).
16 GB
„
5
„
and the
3
„
„
Attention: The hose connection
of the power bank with compressor
1
sure that you do not come into
contact with the hose connection
during operation to avoid suffering
burns. At the end of work, wait
for at least 10 minutes before you
to unscrew the compressed air hose
2
back off the hose connection
the power bank with compressor
Note: After switching on the power
bank with compressor
power bank switch
2
switches off automatically after
Otherwise, the compressor will
switch off automatically once the
inflatable item has reached the
preset pressure.
In this case, once the preset
pressure has been reached and
the compressor automatically
switches off, switch the On/Off
switch for the compressor
(position 0).
Disconnect the inflatable item
from the compressed air hose
as described in the previous
17
section.
At the end of work, screw the
compressed air hose
the hose connection
power bank with compressor
Subsequently, plug the cover cap
for hose connection
the hose connection
heats up during operation. Make
off
2
back off
17
of the
15
.
1
back on to
16
.
15
15
15
17
of
15
.
1
with the
1
, the device
9