ULTIMATE SPEED UPK 10 D1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 14

Using the device
z Check the charge level
of the power bank
with compressor
Switch on the power bank with
„
compressor
1
for the power bank
During charging, the indicator
„
lights will flash
The number of permanently lit
„
indicator lights
charge level of the power bank
with compressor
If the device is fully charged, all
„
four indicator lights
permanently lit.
Indicator lights
0 permanently lit 0%
1 permanently lit 25%
2 permanently lit 50%
3 permanently lit 75%
4 permanently lit 100%
z Charging the power
bank with compressor
Connect the power bank with
„
compressor
1
the network adapter
To do so, plug the cable from the
„
power adapter
ing port (15 V
the power bank with compressor
and then plug into a mains
1
power socket.
14 GB
by using the switch
.
9
.
13
shows the
13
.
1
will be
13
Charge level
to a socket using
.
24
into the charg-
24
/0.4 A) on
10
Attention: Only use the power
adapter as supplied
device!
Note: An undervoltage protection
circuit is installed in the power bank
with compressor
device from damage. This prevents
a deep discharge of the power bank
with compressor
cally switches the device off once
the battery is fully discharged. In this
case, only one of the four blue indi-
cator lights will be lit. In this case,
13
no more energy can be obtained
and the compressor function will
be deactivated. Please recharge
the power bank with compressor
using a network adapter
z Charging mobile
phones and tablets
Press the power switch for the
„
power bank with compressor
once.
Connect a suitable USB
„
charging cable to the USB port
(5V /2A)
11
(5V /1A)
12
into your mobile phone or tablet.
The charging process starts
„
automatically.
Note: You cannot charge USB
devices (e.g. mobile phone, tablet)
while the power bank with compres-
sor itself is being charged.
1
with the
24
to protect the
1
and automati-
1
1
.
24
9
or the USB port
and then plug it