Storage Maintenance And Troubleshooting - Ruris Rxr800 Bedienungsanleitung

EN
Error log
Here you can read the errors and the date of the error.
Work diary
Here you can read the running times of the robot.
settings
Here you can:
- Set the total operating time per day in operating hours.
- Set or change a device password (PIN).
- Enable and disable the rain sensor and set a time when the robot should start working again after rain. You
can also specify whether the indicator should compensate for the break in runtime caused by rain.
It is not recommended to let the robot operate while it is raining.
-Settings
If you select the icon again
robot and the location with "Name" "Location".
"Device information" can be called up under this menu item.
"Tap to run and automate" allows you to run your saved automations.
"Share device" allows you to give other members of the same household access to the robot.
"Offline Message", when enabled, sends you a notification when the app loses connection to the bot.
"Create group" allows you to create groups of devices.
"FAQ" answers to frequently asked questions.
"Check for firmware upgrade" checks if the firmware is up to date and allows upgrading if a newer version is
available.
" Remove device" deletes the robot from the list of devices in the application.
Disconnecting the device and deleting data from the application (for the RXR1000 model).
1. In the setting , select the device you want to remove and whose data you want to delete.
2. Select the icon on the top right.
3. Select "Remove device".
4. To delete data, select "Disconnect and delete data". If you just want to disconnect the device
without deleting the data, select "Disconnect".

7. STORAGE MAINTENANCE AND TROUBLESHOOTING

Cleaning and maintenance
It is important to keep the robotic lawnmower clean.
The robot will climb slopes more easily if the wheels are clean, the blades will also cut better if they are clean
and sharp. Never use a high pressure washer for cleaning.
Cleansing the body
Use a soft brush and/or cloth dampened with household detergent.
Cleaning the underside
Make sure the power switch is in the OFF position and wear protective gloves. Turn the robot on its side to
expose its underside, clean the blade disc and frame using a soft brush or damp cloth. Rotate the disc to make
sure it moves freely.
Sharpening/replacing blades;
If the blades are worn on one side, they can be turned.
If the blades are damaged or show signs of imbalance, they must be replaced.
1. Turn the device over.
2. Remove the blade screws (34) from the bottom of the device, then turn the blades (20).
3. Fix the blades with their screws (34).
Blade replacement
3. Remove the old blades and replace them following the steps above.
recycling
Do not dispose of electrical equipment, industrial electronics and components in household
waste! Information on WEEE. Considering the provisions of GEO 195/2005 - regarding
environmental protection and GEO 5/2015. Consumers will consider the following indications
for handing over electrical waste, specified below:
17
, you can assign a new image to the robot with "Symbol", you can rename the