Ruris RXR800 Bedienungsanleitung Seite 37

EN
Mower lifted
Mower overturned
Mower trapped
Mower tilted
Engine over temperature
Engine error
Emsensor disconnect
Hall sensor failure
Hardware error
Abnormal ladung
Abnormal charging
Battery discharge error
Inertial measurement unit (IMU)
Error
Engine disconnected
Engine hall error
Motor overcurrent
Engine stalls
Right engine stall
Rain sensor failure
Loop sensor failure
Spot mode/Fixed spot mowing mode
This function allows you to mow the lawn when there is, for example, garden furniture or playground
equipment on it.
1. Place the robot on the area where you want to mow the lawn.
2. If necessary, open the cover (1).
3. Unlock the display (10) with the 4-digit PIN (factory setting "1111").
4. Press the OK button (7) to enter the main menu.
5. Select "Spot mode" with the arrow buttons ( 6). The screen shows "Close the cover to start".
6. Close the cover (1) and the robot starts mowing with the fixed point.
The robot mows in a counterclockwise spiral direction and switches to "Automating mowing" after a mowing
radius of 1 m or 3.5 minutes of mowing. If the robot encounters an obstacle, it stops, the display indicates that
mowing has stopped and the robot goes into standby mode. When the robot touches the boundary wire (11), it
continues mowing in the opposite spiral direction.
If the robot is outside the boundary wire (11) or on the charging station and you select "Spot mode", the screen
shows "Place inside the boundary and retry". Place the robot inside the boundary wire (11) next to the
charging station and restart "Spot mode".
If the battery charge level is less than 30%, the display shows "Low battery voltage" after 2 seconds. Charge
the robot before you start mowing.
Setting the date and time
1. If necessary, open the cover (1).
2. Unlock the display (10) with the 4-digit PIN code (factory setting "1111").
3. Press the OK button (7) to enter the main menu.
4. Use the arrow buttons (6) to select "Settings".
5. Confirm the selection with the OK button (7).
6. Use the arrow buttons (6) to select "Date and Time".
7. Confirm the selection with the OK button (7).
8. Change the date and time with the arrow buttons (6). The initial positions can be changed using the OK
button (7). The correct date and time setting is required to ensure the correct operation of the operating time
settings.
Rain sensor setting
Never use the robot during storms and make sure to disconnect the charging station from the mains. If the rain
sensor is turned on, the robot returns to the charging station when it rains.
1. If necessary, open the cover (1).
2. Unlock the display (10) with the 4-digit PIN (factory setting "1111").
3. Press the OK button (7) to enter the main menu.
13
The robot is lifted off the ground
The robot overturned
Clean the robot and restart it
Place the robot upright and restart it
Turn off the robot and let it cool down
Contact an authorized RURIS service