Ruris RXR800 Bedienungsanleitung Seite 40

EN
If you are not automatically suggested a list of available devices:
If the device is not automatically suggested, follow these steps:
9. In the setting , select
10.Select "Other" in the left bar.
11.Select "Other 2".
12.Confirmation is ready when the display flashes quickly. The app now searches for available devices and
suggests them to you.
13. Select the desired device by pressing
14.First confirm with "Next", then with "Finish".
Updating the firmware may change the features of the application.
Enabling Bluetooth (for RXR1000 model).
Bluetooth is only required to connect your device to the Smart Life App.
After the device is connected to the Smart Life App, Bluetooth turns off and turns on again only when the
device is reset to factory settings.
1. If necessary, open the cover (1).
2. Unlock the display (10) with the 4-digit PIN (factory set "1111").
3. Press the OK button (7) to access the main menu.
4. Use the arrow button (6) to select "Setting".
5. Confirm the selection with the OK button (7).
6. Use the arrow button (6) to select "Set WiFi".
7. Confirm the selection with the OK button (7).
This is required for the initial connection with the Tuya Smart app, for which there is a WLAN connection and
the robot's Bluetooth function is inactive.
App features (for RXR1000 model).
If you select the robot, it will take you to the overview page.
Press the circle button on the left and hold your finger on the display to slide the "START >" button
Select the individual menus via the button "START > " position.
•
Time schedule
Here you can set two operating periods for each day of the week.
The robot must be in standby mode so you can do the sequences you want.
1. Select the desired day.
2. For the desired time period, define a Start time and an End time.
3. Save the program in the top right at "Save".
The program can be reset from the menu on the right by "Reset".
•
Secondary areas.
Here you can configure up to 5 secondary zones. The robot must be in standby mode so that you can make
settings here.
1. Select a secondary zone.
2. Set the distance to the entry point.
The robot moves along the boundary wire for the specified distance and then starts mowing.
3. Set a percentage of the area.
Area percentage indicates what percentage of the total area inside the boundary wire is to be mowed.
The sum of the area percentages of the 5 secondary areas must be less than or equal to 100% of the total
area.
4. Confirm with "Save".
If you do not want to divide the mowing area into a secondary area, select:
•
Distance to entry point: 1 m
•
Area percentage: 100%
Control
Here you can:
- View how the robot is currently;
- View battery capacity in percentage;
- Start or stop automatic trimming
- Start mowing on the spot through the fixed point
This function allows you to mow lawns on which there are furniture bodies, or other similar objects.
- By selecting the button
16
at the top right.
to add it to the application.
;
, the robot will move to the charging station.
, select if the robot is in standby mode.