Ruris RXR800 Bedienungsanleitung Seite 35

EN
- if the battery charge level is higher than 30%, the display shows "Close the cover to start". Close the cover
(1) and the robot will automatically start mowing the lawn.
- if the battery charge level is less than 30%, the display shows "Low battery" after 2 seconds. The robot
moves to the charging station.
Depending on the nature of the grass (height, thickness), the robot adjusts its mowing speed to ensure a good
result.
Back to the charging station
When the robot is in standby mode, press and hold the HOME button (4) for about 3 seconds. The display (10)
shows "Close the cover to start". Close the cover (1) and the robot moves to the charging station. Then it
starts charging.
Robot settings
The robot has the following setting options that you can do via the control panel if you want to change the
factory settings.
Button on the
control panel
Home Button
OK button(7)
Explanation of messages that may appear on the display
Message on the control panel
Standby
Input PIN
Charging
Mowing
Auto mowing
Fashion spot
Fixed point mowing finished
Returning
Paused
Emergency stop
Updating
11
Number to
Name enter the PIN
code
(4)
Arrow
Button(6)
Arrow
Button(6)
back
button(5)
Explanation/Remedial solution
The robot is in standby mode, there are no error messages
It asks for the PIN code
The robot is charging
The robot mows the grass
The robot mows the grass automatically
The robot mows a defined area
Trimming in "spot mode" has been completed
The robot returns to the charging station
The robot entered the "pause" mode by:
- pressing the STOP button
- pressing the "Pause" button in the APP
The STOP button (9) was pressed.
Perform/in progress required firmware
Press the button when the robot is in standby
1
mode to make it return to the charging station
Moves the selection/cursor up in the menu
2
Increases the number when setting
Moves the selection/cursor down in the menu
3
Decrease the number when setting
Calls the PIN input interface after an error
4
Confirm to move from the main menu to the
Functions
interface
parameters
interface
parameters
Confirm the settings
condition has ended
Call up the next menu
next menu level
Back to previous menu
Cancel the next function