Putting Into Service; Initial Start-Up; Starting And Stopping - Ruris Rxr800 Bedienungsanleitung

EN

6. PUTTING INTO SERVICE

6.1 INITIAL START-UP

Starting the robot
1. Press and hold the START button (3) for approx. 3 seconds until the display (10) lights up.
2. Set the desired language. Select the desired language using the arrow buttons (6) and confirm the selection
with the OK button (7).
3. Set the date and time with the arrow buttons (6). Confirm the selection with the OK button (7). The correct
date and time setting is required to ensure the correct operation of the operating time settings.
4. Enter the 4-digit PIN code (factory setting "1111").
Change the factory set password after the first start-up.
5. Press the OK button (7) to enter the main menu. The robot is now in standby mode.
Language setting
1. If necessary, open the cover (1).
2. Unlock the display (10) by entering the 4-digit PIN code (factory setting "1111").
3. Press the OK button (7) to enter the main menu.
4. Use the arrow buttons (6) to select the "Settings" menu
5. Confirm the selection with the OK button (7)
6. Use the arrow buttons (6) to select "Language"
7. Confirm the selection with the OK button (7)
8. Use the arrow buttons (6) to select the desired language
9. Confirm the selection with the OK button (7)
10.Return to the main menu with the back button (5).

6.2 STARTING AND STOPPING

Starting the robot
1. Press and hold the START button (3) for approx. 3 seconds until the display (10) lights up.
2. Enter the 4-digit PIN code (factory setting "1111").
3. Press the OK button (7) to enter the main menu. The robot is now in standby mode. If the robot is in standby
or charging mode, press the START button (3) once to start mowing. The robot will not start until the lid (1) is
closed.
If you entered the wrong PIN. Wait about 3 seconds or press the OK button (7) to be able to enter the PIN
code again. If you enter an incorrect PIN three times in a row, the screen is locked for 15 seconds. For each
additional incorrect PIN, the blocking time is doubled. Stopping the robot
1. Press and hold the START button (3) for about 3 seconds.
The robot stops if:
1. The STOP button (9) is pressed
2. The START button (3) is pressed for 3 seconds
3. The cover (1) is lifted
4. The robot loses the boundary wire signal and cannot find it again in 5 minutes
5. Cross the boundary line.
6. Gets stuck between obstacles and needs more than 10 seconds to find a way out.
7. It is elevated
6.3 LAWN MOWING
1.Open the cover (1).
2. Unlock the display (10) with the 4-digit PIN code (factory setting "1111").
When the robot is in the charging station and charging:
3. Press the START button (3) once.
- if the battery charge level is higher than 70%, the display shows "Close the cover to start". Close the cover
(1) and the robot will automatically start mowing the lawn.
- if the battery charge level is less than 70%, the display shows "Low battery" after 2 seconds. The robot
charges until the battery level is 90% and then starts mowing automatically.
When the robot is in standby mode:
3. Press the START button (3) once.
10