Valve Adapter; Working Instructions; Changing The Pressure Setting; Cleaning And Servicing - Parkside Pak 20-Li B2 Originalbetriebsanleitung

GB IE

Valve adapter

Valve adapter
a:
Valve adapter
b:
Valve adapter
c:
Valve adapter
d, f:
Valve adapter
e:
Ball needle::
Valve adapter
for Presta val-
ves:
Valve adapter
for Dunlop/
Woods valves:

Working instructions

Changing the pressure
setting
(only the cordless compres-
sor)
1. Switch the display (4) on the cordless
compressor on (see "Switching on/
off").
2. Press the "+" button (7) on the display
(4) to increase the pressure setting.
Press and hold the "+" button (7) for
approx. 3 seconds. The numbers on
the display (4) begin to fl ash. You can
28
For all standard valves
with an internal diame-
ter from 8 mm.
For infl atable items with
a screw-on valve. Defl a-
tion is only possible with
the valve unscrewed
and with adapter b.
For infl atable items with
an exhaust valve.
For infl ating air mattres-
ses and the like.
For infl ating water balls
and the like.
For infl ating different
balls.
For infl ating bicycle
tyres.
For infl ating bicycle
tyres.
now increase the preset value by pres-
sing the "+" button (7). The number is
increased by 0.1 bar / 1 PSI each time
you press.
3. To decrease the preset value, proceed
in the same way but using the "-" but-
ton (5).
By briefl y pressing the On/off
button (6) on the display, you can
switch the display of the pressu-
re unit between "bar" and "psi"
(pounds per square inch). The
display (4) has to be on (see "Swit-
ching on/off").

Cleaning and Servicing

Switch off the device and
remove the battery before
carrying out any maintenan-
ce work.
You should have any repair and
maintenance work that is not de-
scribed in these instructions carried
out by our Service Centre. Only use
original parts.
Perform the following maintenance and cle-
aning work regularly. This will guarantee
long and reliable use.

Cleaning

The device must not be
sprayed with water or placed
in water. Otherwise there is
a risk of electric shock.
Do not use any cleaning agents or
solvents. This could damage the
device irreparably. Chemical subs-
tances may attack the plastic parts
of the device.