Switching On And Off - Parkside Pak 20-Li B2 Originalbetriebsanleitung

GB IE
PLG 20 A4
Charging
PLG 20 C1
time (min.)
PAP 20 B1
PAP 20 B3
120
1. Remove the battery (24) from the ap-
pliance, as necessary (see „Removing/
inserting the battery").
2. Insert the battery (24) in the charging
compartment of the battery charger
(26).
3. Plug the battery charger (26) into a
mains outlet.
4. When the battery is fully recharged
unplug the battery charger (26) from
the mains.
5. Remove the battery (24) from the char-
ger (26).

Switching on and off

Cordless air pump
1. To switch the device on, move
the On/off switch (20) to positi-
on "1". The LED work light (19)
lights up.
2. To switch the device off, move
the On/off switch (20) to positi-
on "0".
Switching on the cordless
compressor, variant 1:
1. Press the On/off button (6) on
the display (4) to switch the de-
vice on. The display (4) shows
the preconfi gured pressure (see
"Changing the pressure setting").
2. Press the On/off switch (10). The
device turns on.
-> When the preconfi gured
pressure is reached, the device
switches off automatically.
26
PLG 20 A3
PLG 20 C3
PDSLG 20 A1
60 30
60
3. To start the device again, press
the On/off switch (10) twice.
Switching on the cordless
compressor, variant 2:
1. Press the On/off switch (10) di-
rectly.
- the display switches on,
- the device starts,
-> the device switches off auto-
matically when the preconfi -
gured pressure is reached.
2. To start the device again, press
the On/off switch (10) twice.
If your device does not start by
pressing the on/off switch (10),
either the on/off button (6) must be
pressed on the display (4), or the
on/off switch (10) needs to be pres-
sed twice.
Switching off the cordless
compressor
1. Press the On/off switch (10)
once.
2. Press and hold the On/off button
(6) for 3 seconds.
The display (4) goes out. The
preconfi gured pressure is saved.
The devices are not suitable for
long-term use. Operation for over
20 minutes can cause overheating
and damage to the devices. If the
device is overloaded, switch it off
immediately and only put it back
into operation when it has cooled
down.