Create Wind Tube Bedienungsanleitung Seite 8

INSTAL L ATION PRE PAR AT I O N
• To avoid personal injury and damage, make
sure the blade hanging location leaves 2.3 m
of ground clearance and 76 cm of any wall
or obstacle.
MECH AN I C TIP S
• In accordance with safety regulations, the lowest point of the fan blades must be at least
2.3 meters from the ground.
• Make sure the chosen location does not allow the rotating blades to come into contact
with any objects.
• Check that the ceiling joists are secure and large and strong enough to support the weight
of the fan.
• To reduce the risk of fire, electric shock, or personal injury, ensure the fan mounting
bracket is attached directly to the building structure. DO NOT mount in a distribution box.
• The mounting bracket must be securely bolted to a supporting structure, such as a
concrete roof, steel structure, or wooden frame. If a wooden frame is added, it should be
nailed or screwed securely between two joists.
• To reduce the risk of personal injury and property damage, do not bend or damage the
vertical rod or fan blades when handling or installing the fan. If you detect any damage
to the product, contact our after-sales service before proceeding with the installation of
the fan.
• Make sure the fan is securely attached to the ceiling. All fixing screws should be checked
and retightened whenever necessary before starting the fan.
E LECTR ICAL T IP S
• Turn off the power before performing any work on the ceiling fan and turn off the power
breaker. To avoid possible electrical shock, check that the power is turned off at the fuse
box or circuit breaker panel before wiring.
• The fan, mounting bracket and lighting equipment must be connected to the ground.
Check that all splices are well insulated.
• Check and confirm that all connections are correct and secure. Once all electrical
connections have been made, store all cables securely.
• Do not attempt to control this fan from a wall switch or remote control that is not approved
by the manufacturer for use with the fan. DO NOT use a solid state controller. Use of a non-
approved wall switch or remote control will void your warranty.
• Do not connect the ceiling fan to a dimmer switch.
E NGL I SH
8
INSTALLATION INSTRUCTIONS
76 cm
separation
between
the wall or
2.3 m from the
obstacle.
blades to the
ground