Stihl RGA 140 Gebrauchsanleitung Seite 40

English
18.5 Sharpening the Blades
WARNING
■ The cutting edges of the blades are sharp.
There is a risk of cutting oneself.
► Wear work gloves made of robust material.
► Switch off the weeder.
► Remove blades.
2
► Use a STIHL flat file to sharpen the cutting
edge (2). The file only sharpens on the for‐
20 Troubleshooting
20.1 Troubleshooting the Weeder or Battery
Fault LEDs on the
battery
The weeder does 1 LED flashes
not start when green.
switched on.
1 LED emits
red light.
3 LEDs flash
red.
3 LEDs light
up red.
4 LEDs
flash red.
-
40
1
Cause
State of charge of the
battery is too low.
The battery is too
warm or too cold.
There is a fault in the
weeder.
The weeder is too
warm
There is a fault in the
battery.
There is a break in the
electrical connection
between the weeder
and the battery.
The weeder or battery
is damp.
Trigger is pressed
before operating the
unlock button.
ward stroke. Maintain the specified sharpening
angle, 21.2.
► Sharpen the other cutting edges.
► Install the blades.
► If you are unsure: Consult a STIHL servicing
dealer.
19 Repairing
19.1 Repairing the Weeder
The user cannot repair the weeder.
► If the weeder is damaged: Do not use the
weeder; contact a STIHL servicing dealer.
19.2 Servicing and Repairing the
Battery
The battery requires no servicing and cannot be
repaired.
► If the battery has a malfunction or is damaged:
Replace the battery.
Remedy
► Recharge the battery fully as described in
the User Manual for the STIHL AL 101,
301, 301-4, 500 chargers.
► Remove the battery.
► Allow the battery to cool down or warm
up.
► Remove the battery.
► Clean electrical contacts in the battery
compartment.
► Insert battery.
► Switch on weeder.
► If 3 LEDs continue to flash red: Do not
use the weeder; contact a STIHL servi‐
cing dealer.
► Remove the battery.
► Allow the weeder to cool down.
► Remove battery and reinsert it.
► Switch on weeder.
► If 4 LEDs continue to flash red: Do not
use the battery; contact a STIHL authori‐
zed dealer.
► Remove the battery.
► Clean electrical contacts in the battery
compartment.
► Insert battery.
► Allow the weeder or battery to dry,
21.5.
► Switch on the weeder as described in this
User Manual.
19 Repairing
0458-845-9602-A