Futurelight DMX SPLIT 6 Bedienungsanleitung Seite 17

The DMX control signal can be transmitted wirelessly to the splitter using a CRMX transmitter. Alternatively, a
conventional cable connection can be used. In CRMX mode, you can flexibly set up point-to-point and multipoint
connections over long distances and in any environment. Adaptive frequency hopping enables interference-free
operation alongside Bluetooth and Wi-Fi. Depending on the ambient conditions, parallel operation with up to 10
DMX universes is possible. There is no limitation for the number of receivers linked to a transmitter.
Point-to-point connection
Point-to-multipoint connection
Multipoint connection
APPLICATIONS
17 • EN
The DMX signal is
transmitter which sends it via RF. A
receiver with the same transmission
protocol receives the RF signal and
distributes it as a DMX signal.
The DMX signal is
transmitter which sends it via RF. An
unlimited number of receivers with
the same transmission
receive the RF signal and distribute it
as a DMX signal.
Up to 10 DMX universes may be
transmitted simultaneously
multipoint-to-multipoint operation. All
receivers will respond only to the
designated transmitter without any
delay or interference from other
systems.
fed to a
fed to a
protocol
using