Cleaning The Inlet Screen; Accessories - Tuthill Fill-Rite Portable Rd Serie Betriebs- Und Sicherheitsanleitung

Troubleshooting
Symptom
Fluid leakage
Pump hums but will not
operate
Motor overheats.
Motor inoperative.
Bold text indicates repairs that are not serviceable
Cleaning the Inlet Screen
Regular inspection and cleaning of the inlet screen on your RD
series pump helps maintain performance
screen by removing the inlet flange as described on page 5.
Clean, rinse, and dry the screen throughly
Inspect the screen, seals, and flange area for debris and
damage. If screen or O-rings are damaged,
KIT812SL.

Accessories

Accessory
1200KTF7018
F1810PMO
1210KTF7019
F1810HMO
FRHMN075S
(cont'd)
Cause
Bad O-ring gasket.
Bad shaft seal.
Incompatible fluid.
Loose fasteners.
Inadequate plumbing seals.
Motor failure.
Pumping high viscosity fluids.
Clogged screen.
Restricted suction pipe.
Motor failure.
Pump rotor lock-up
No power.
Switch failure.
Incorrect or loose wiring.
No power.
Switch failure.
Motor failure.
Motor overheated
Incorrect or loose wiring.
Fuse has blown.
by the owner; pump must be returned to the point of purchase
and flow. Access the
before re-installing.
10 Micron Particulate Filter Kit (Bung mount installations only)
10 Micron Replacement
Hydrosorb Filter Kit (Bung mount installations only)
Hydrosorb Replacement
3/4" Manual Nozzle
Check all o-rings
Return to place
Refer to wetted parts list (page 10).
Tighten fasteners.
Reseal plumbing connections.
Return to place of purchase.
These fluids can only be pumped for short periods of
time (less than the 30 minute duty cycle)
Remove and
Remove and clean pipe.
Return to place of purchase.
Clean and inspect rotor and vanes
Check incoming power.
Return to place of purchase.
Check wiring / connections
Check incoming power.
Return to place of purchase.
Return to place of purchase.
Switch off and
Check wiring / connections.
Replace 30A fuse.
replace with kit
Description
Spin-on Filter (Particulate)
Spin-on filter. (Bung mount installations only)
9
n 7üthi//
Cure
of purchase.
clean screen.
allow to cool.
(Bung mount installations only)
for repairs.
Screen