Angelo Po 10NCP1EA Bedienhandbuch Seite 55

SERVICING
Since the appliance is used for preparing foods
for human consumption, special care must be
paid to everything relating to hygiene, and the
appliance and the entire surrounding environ-
ment must constantly be kept clean.
WARNING: Before starting any clea-
ning operation, always turn off the gas sup-
ply tap, cut off the electricity supply using
the master switch and allow the appliance to
cool.
The precautions which follow are also impor-
tant.
WARNING: When using detergents,
rubber gloves, protective mask and safety
goggles must be worn in accordance with the
relevant safety regulations.
– Clean all parts of the appliance with warm
water, food-approved detergents and non-
abrasive materials only.
CLEANING THE WATER LEVEL SENSOR ELECTRODES
Proceed as follows.
Raise the electrode holder (A).
1)
WARNING: Take care over the con-
nection cable (B).
Clean the electrode holder (A) and the elec-
2)
trodes (C) with a non-abrasive sponge and a
food-approved detergent.
Rinse thoroughly to remove all residues of
3)
the product used and dry.
Rinse the guide tube of the electrode holder
4)
(D) with drinking water.
WARNING: The guide tube of the
electrode holder is in communication with
the cooking well. Do not allow dirt or chemi-
cals to enter the tube.
3329650_ut_GB_rev.1
– Thoroughly clean all parts which come into
direct or indirect contact with foods and all
surrounding areas.
– After use, clean the accessories with a suit-
able grease-remover product. If possible,
wash in the dishwasher.
WARNING: Never use products con-
taining substances harmful or hazardous for
health (solvents, petroleum spirits, etc.).
– Rinse surfaces with drinking water and dry.
– Pressurised water jets may only be used on
external parts.
– Take special care not to damage stainless
steel surfaces. In particular, avoid the use of
corrosive products and do not use abrasive
materials or sharp tools.
– Remove food residues immediately before
they set.
– Remove the limescale deposits which may
form on some of the appliance's surfaces.
C
B
Clean the cooking well and empty it to re-
5)
move any cleaning residues (see page 20).
Replace the electrode holder (A).
6)
ENGLISH
A
D
25