Tractel Tracrod base Installations-, Gebrauchs- Und Wartungsanleitung Seite 15

• to install a Tractel
®
vice using fasteners whose strength, diameter,
number or tightening torque would not comply
with the specifications in this manual.
• to connect to this equipment by any means oth-
er than a fall arrest system.
• to install on this equipment another anchoring
rod than the Tracrod anchoring rod manufac-
tured by Tractel
®
7. Associated equipment
Fall-arrester system (EN 363):
• An anchorage device (EN 795).
• An end connector (EN 362).
• A fall arrest system (EN 360).
• A connector (EN 362).
• A fall arrest harness (EN 361).
8. Maintenance and storage
If the fall arrest system is dirty, it should be
washed in clear, cold water with a mild detergent
if necessary, using a synthetic brush.
During transport and storage, protect the equip-
ment from any risk of damage (sharp edges, di-
rect heat source, chemicals, UV, etc.).
9. Equipment compliance
TRACTEL SAS RD 619 - Saint-Hilaire- sous-
Romilly - F-10102 Romilly-sur-Seine France
hereby declares that the safety equipment de-
scribed in this manual,
• is identical to the PPE, having been subject
to the "CE"-type-examination certificate is-
sued by the APAVE Exploitation France SAS
(n°0082) – 6 Rue du Général Audran – 92412
COURBEVOIE cedex – France, identified un-
der the number 0082, and tested according to
standard EN 795-A:2012 for 1 operator et TS
16415:2013 for 2 operators.
fall arrest anchorage de-
10. Marking
The marking of the Tractel
indicates:
a. the trade name: TRACTEL
b. The description of the product,
c. the reference standard followed by the year
of application,
d. this equipment reference.
f. year and month of manufacture.
g. The following serial number or solar date the
case,
h. a pictogram showing that the manual must be
read before use,
w. Maximum operating load,
o. Minimum resistance to failure of the anchor-
age device,
p. Maximum number of operators who can use
the anchoring device simultaneously.
aa. Date of the next periodic review,
ae. Commissioning date
af. Fall arrest anchoring device
11. Periodic inspection and repair
An annual periodic inspection is required, but
depending on the frequency of use, environmen-
tal conditions and regulations of the company or
the country of use, periodic inspections may be
more frequent.
Periodic inspections must be carried out by an
authorised and competent technician and in ac-
cordance with the manufacturer's examination
procedures as set out in the "Tractel
fication Instructions" file.
Confirmation of the legibility of the product mark-
ings should be an integral part of the periodic
inspection.
fall arrest anchors
®
,
®
PPE Veri-
®
15
EN