Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7. Emergency mode
N1 Operation with cable - Fig. 2.2
Radio interferences might also be the cause for
improper operation of the remote control. In that
case use the connection cable and connect the
remote control to the Basic Station.
Connection of the cable in the remote control is
effected by opening the battery compartment on
the lower side and by insertion of the plug into the
socket being located near the batteries.
N2 Batteries - Fig. 2.2
The cable also can be used if the batteries of the
remote control are used up.
Only use leak-proof batteries 1.5 V Type AA.
Observe
PLUS/MINUS
batteries!
Empty, worn out batteries might be leaky, which
might result in damage of the remote control!
Remove the batteries, if the remote control has
not been used for an extended period.
Any guaranty claim for damages caused by leaky
batteries is void.
GB10
Basic station
when
inserting
new
N3 Engaging and disengaging the
friction rollers by hand
(Emergency mode Pivoting System -
Fig. 3.2 to 3.5):
Use a suitable allen wrench to remove the
support bracket on the housing front. You may
optionally pivot the PS in and out of position by
rotating the 13 mm allen wrench.
Turning clockwise = Engaging - ON
(Fig. 3.3 and 3.5)
Turning anticlockwise = Disengaging - OFF
(Fig. 3.3 and 3.4)
Caution: The drive unit must always be travelled
to the corresponding final position!!
Werbung
