Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7
OPERATION
Starting the Device
Carry out the following steps to take the unit into operation:
1
Check to see whether all laser safety precautions have been taken. Make sure that nobody is in range
of the laser beam.
2
Insert the safety key into the lock.
3
If not already done, connect the device to a mains power outlet and the emergency switch.
4
Turn the unit on using the power switch. The power indicators lights up. The unit is now operational.
5
Turn the safety key to turn the laser beam on.
6
Now you can start the projection from your software or laser controller.
7
With the brightness controls R, G and B you can adjust the color balance for the red, green and blue
laser diode.
8
With the controls X SIZE and Y SIZE you can adjust the horizontal and vertical extend of the laser
show.
9
With the switches X INVERS and Y INVERS you can select mirroring on the X and Y axis.
10
In the event of a dangerous situation, immediately turn off the laser system with the power switch or the
remote emergency switch.
Stopping the device
Carry out the following steps to stop the unit:
1
Turn the safety key to turn the laser beam off and pull the key off. Keep the safety key in a safe place.
2
Turn the unit off using the power switch or the remote emergency switch
3
Additionally, you can disconnect the device from the power supply.
www.futurelight.com
33
Werbung
Inhaltsverzeichnis
