6
SETUP
Establish all connections as long as the unit is switched off.
Standard connection for operation with Notebook and external ILDA-compatible controller,
Emergency Switch
ILDA Interfaces
You can connect laser control units that generate signals as standardized by the International Laser Display
Association to the ILDA input. Matching items such as the HE laser software by EUROLITE are available as
accessory.
The ILDA output of the unit can be connected to other laser devices. The ILDA interfaces are designed as
25-pin D-sub connectors.
Power Connection
The device is equipped with a lockable power input connector. Plug in the power cord and turn it to the right
until it locks. Plug the power cord into a grounded electrical outlet that matches the rated voltage of the
machine.
www.futurelight.com
e.g. EUROLITE HE laser software and interface
Connect the optional remote emergency switch to the INTERLOCK jack of the
device.
If you press the switch, the laser beam is switched off immediately.
To unlock the switch and resume operation, turn the knob clockwise.
32