Resistance Measurement - Ht Instruments Ht401 Bedienungsanleitung

5.6.

RESISTANCE MEASUREMENT

Before attempting any resistance measurement, cut off power supply from
the circuit to be measured and make sure that all capacitors are discharged,
if present.
1. Select the position  /
2. Insert the red cable into input lead
3. Press the RANGE key to activate manual range selection (see § 4.2.1) or use the
Autorange feature. If the resistance value is unknown select the maximum range
4. Position the test leads in the desired points of the circuit to be measured. The value of
resistance is shown on the display (see Fig. 7)
5. The message "O.L" indicates that the resistance being measured exceeds the
maximum value measurable by the instrument.
6. For Maximum and Minimum value measurement and HOLD function please refer to §
4.2
CAUTION
Fig. 7: Resistance measurement
V and the black cable into input lead COM
EN - 14
HT401