HomeMatic IP HmIP-eTRV-B-2 Installations- Und Bedienungsanleitung Seite 33

Configuration menu
7.2 Automatic mode
In automatic mode, the temperature is
controlled in accordance with the set
heating schedule. Manual changes are
enabled until the next point at which
the profile changes. Afterwards, the
defined heating schedule will be ena-
bled again. To enable automatic mode,
proceed as follows:
• Press and hold the menu button
(G) for approx. 2 seconds to open
the configuration menu.
• Select the "Auto" menu item using
the plus and minus buttons (E + F).
• Confirm with the menu button.
To confirm, the symbol briefly flashes
twice and the device changes back to
automatic mode.
7.3 Holiday mode
If you would like to maintain a con-
stant temperature for a certain period,
e.g. during your holidays or a party, the
holiday mode can be used. To enable
the holiday mode, proceed as follows:
• Press and hold the menu button
(G) for approx. 2 seconds to open
the configuration menu.
• Select the "Holiday" menu item
using the plus or minus buttons
(E + F) and confirm with the menu
button.
• Use the plus and minus buttons
to select the time until which you
would like to enable the holiday
mode and confirm with the menu
button.
• Use the plus and minus buttons
to select the date until which you
would like to enable the holiday
mode and confirm with the menu
button.
• Use the plus and minus buttons
to select the temperature for the
holiday mode and confirm with the
menu button.
To confirm, the symbol briefly flashes
twice and the device changes to holi-
day mode.
7.4 Operating lock
Operation of the device can be locked
to avoid settings being changed un-
intended (e.g. through involuntary
touch). To enable or disable the oper-
ating lock, proceed as follows:
• Press and hold the menu button
(G) for approx. 2 seconds to open
the configuration menu.
• Select the "Operating lock" menu
item using the plus and minus but-
tons (E + F).
• Confirm with the menu button.
• Use the plus button to select "On"
if you would like to enable the op-
erating lock or "OFF" to disable the
operating lock and confirm with
the menu button.
To confirm, On or OFF flashes twice
and the device changes back to the
standard display.
After activating the operating lock, the
"lock" symbol is shown in the display.
To disable the operating lock, proceed
as follows:
• Press and hold the menu button (E)
for approx. 2 seconds to open the
configuration menu.
• Confirm with the menu button.
33