HomeMatic IP HmIP-eTRV-B-2 Installations- Und Bedienungsanleitung Seite 32

Configuration menu
the device to the valve. To do this, pro-
ceed as follows:
• As soon as "AdA" is displayed, press
the menu/boost button (G) to start
the adjustment run.
2
Figure 9
7 Configuration menu
If you operate the device without a
Homematic IP Access Point, after start-
up you can use the configuration menu
to directly select the following modes
and adjust the settings to adapt the
device to your personal needs:
• Press and hold the menu but-
ton (G) to enter the configuration
menu.
• Select the desired icon via the
plus and minus buttons (E + F) by
pressing the menu button briefly to
change the settings of the different
menu items.
Press and hold the menu button
(G) to return to the previous level.
The menu automatically closes
without applying changes if there
is no operation for more than 1
minute.
1
If you pair the device with the
Homematic IP Access Point, you
can easily adjust the settings using
the free Homematic IP app.
If you have already adjusted the
settings in the configuration
menu, or if you have already di-
rectly paired the device with an-
other Homematic IP device, you
first have to restore the factory
settings of the device before you
can pair the radiator thermostat
with a Homematic IP Access Point
or a Central Control Unit CCU3
(see „11 Restoring factory settings"
on page 39).
7.1 Manual mode
In manual mode, the temperature is
controlled in accordance with the cur-
rent temperature set via the push-but-
tons (E + F). The temperature remains
enabled until the next manual change.
To enable the manual mode, proceed
as follows:
• Press and hold the menu button
(G) for approx. 2 seconds to open
the configuration menu.
• Select the "Manu" menu item using
the plus and minus buttons (E + F).
• Confirm with the menu button.
To confirm, the symbol briefly flashes
twice and the device changes back to
automatic mode.
32