HomeMatic IP HmIP-eTRV-B-2 Installations- Und Bedienungsanleitung Seite 28

Start-up
• Press and hold the system button
(D) for at least 4 seconds to enable
the pairing mode. The device LED
(D) starts to flash orange. The pai-
ring mode is active for 3 minutes.
• Press and hold the system button
of the device you would like to
connect (e.g. the Homematic IP
Window / Door Contact with ma-
gnet) for at least 4 seconds to
enable the pairing mode. The de-
vice LED starts to flash orange. For
further information, please refer to
the operating manual of the corre-
sponding device.
4 s
Figure 3
The device LED lights up green to indi-
cate that pairing has been successful.
If pairing has failed, the device LED
lights up red. Please try again.
If no pairing operations are per-
formed, pairing mode is exited
automatically after 3 minutes.
If you would like to add another
device to an existing device group,
first enable the pairing mode of
the existing device in the group
and afterwards the pairing mode
of the new device.
If you would like to add a wall
thermostat to an existing device
group including a radiator ther-
mostat and a window and door
contact, you first need to pair the
wall thermostat with the radiator
thermostat. Afterwards, you can
pair the wall thermostat with the
window and door contact.
If you are using several devices in
one room, you should pair all
devices with each other.
6.1.2 Pairing with the Access Point
If you have already directly paired
the device with another
Homematic IP device, you first
have to restore the factory set-
tings of the device before you can
pair the radiator thermostat with
the Homematic IP Access Point or
the Central Control Unit CCU3
(see „11 Restoring factory settings"
on page 39).
First set up your Homematic IP
Access Point using the
Homematic IP app so that you can
use other Homematic IP devices
in the system. For further informa-
tion, please refer to the Ac-
cess Point operating manual.
For more information on pairing
and setting up the wall thermostat
using a CCU3, please refer to the
WebUI manual on our homepage
at www.homematic-ip.com.
28