HomeMatic IP HmIP-eTRV-B-2 Installations- Und Bedienungsanleitung Seite 29

Start-up
The device must first be paired with
the Homematic IP Access Point so
that it can be integrated into your
system and communicate with other
Homematic IP devices.
To add the device, proceed as follows:
• Open the Homematic IP app on
your smartphone.
• Select the menu item "Pair device".
• Open the battery compartment (B)
by pulling the battery compart-
ment cover downwards
(see figure).
• Remove the insulation strip from
the battery compartment. The pair-
ing mode is active for 3 minutes.
You can manually start the pairing
mode for another 3 minutes by
briefly pressing the system button
(D).
Figure 4
Your device will automatically appear
in the Homematic IP app.
• To confirm, enter the last four dig-
its of the device number (SGTIN) in
your app, or scan the QR code. The
device number is on the sticker in
the package contents or attached
to the device.
• Wait until pairing is completed.
• If pairing was successful, the LED
(D) lights up green. The device is
now ready for use.
• If the LED lights up red, please try
again.
• In the app, give the device a name
and allocate it to a room.
6.2 Installation
Please read this entire section
before starting the installation.
The Homematic IP Radiator Thermo-
stat is easy to install, and can be done
without draining heating water or in-
tervening in the heating system. No
special tools are required, nor does the
heating have to be switched off.
The union nut (A) attached to the radi-
ator thermostat can be used universally
and without accessories for all valves
with a thread size of M30 x 1.5 mm
from the most popular manufacturers,
such as:
• Heimeier
• MNG
• Junkers
• Landis&Gyr (Duodyr)
• Honeywell-Braukmann
• Oventrop
• Schlösser
• Comap
• Valf Sanayii
• Mertik Maxitrol
• Watts
29