Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Open the back cover, ; and take off the isolating film on the batteries;
2. Put the batteries inside the slot, with anode and cathode in right directions;
3. Put on the back cover.
Notices:
1) The anode and cathode of the batteries must be corresponding to the signs of "+"
and "-" on the remote control;
2) Do not use new battery cells together with run-down cells;
3) For long time no use, take out the batteries;
4) To prevent environmental pollution, take out the used batteries and dispose safely
and appropriately.
How to Use
•
To operate the air conditioner, aim the
remote controller at the signal receptor.
The remote controller will operate the air
conditioner at distance of up to 5m (16.4
feet) when pointing at singal receptor of
the air conditioner
Protection
The protective device may trip and stop the appliance in the cases listed below.
Cooling
Dehumidifying
lf the air conditioner runs in COoLING or DRY mode with door or window opened
for a long time when relativehumidity is above 80%,dew may drip down from the
outlet.
1
The protective device will work in the following cases.
•
Restarting the unit at once after operation stops or changing mode during
operation, you need to wait 3 minutes.
•
lf the plug is taken out, when you restart the appliance, it will return to the
original mode,TIMER ON and TIMER OFF must be set again,
Operating condition
Indoor air temperature is over 43
Room temperature is below 15
Room temperature is below 15
Features of protector
signal receptor
℃
℃
℃
10
Werbung
